CVD solutions for new directions in SiC and GaN epitaxy

Download or read book CVD solutions for new directions in SiC and GaN epitaxy written by Xun Li and published by Linköping University Electronic Press. This book was released on 2015-05-22 with total page 57 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis aims to develop a chemical vapor deposition (CVD) process for the new directions in both silicon carbon (SiC) and gallium nitride (GaN) epitaxial growth. The properties of the grown epitaxial layers are investigated in detail in order to have a deep understanding. SiC is a promising wide band gap semiconductor material which could be utilized for fabricating high-power and high-frequency devices. 3C-SiC is the only polytype with a cubic structure and has superior physical properties over other common SiC polytypes, such as high hole/electron mobility and low interface trap density with oxide. Due to lack of commercial native substrates, 3C-SiC is mainly grown on the cheap silicon (Si) substrates. However, there’s a large mismatch in both lattice constants and thermal expansion coefficients leading to a high density of defects in the epitaxial layers. In paper 1, the new CVD solution for growing high quality double-position-boundaries free 3C-SiC using on-axis 4H-SiC substrates is presented. Reproducible growth parameters, including temperature, C/Si ratio, ramp-up condition, Si/H2 ratio, N2 addition and pressure, are covered in this study. GaN is another attractive wide band gap semiconductor for power devices and optoelectronic applications. In the GaN-based transistors, carbon is often exploited to dope the buffer layer to be semi-insulating in order to isolate the device active region from the substrate. The conventional way is to use the carbon atoms on the gallium precursor and control the incorporation by tuning the process parameters, e.g. temperature, pressure. However, there’s a risk of obtaining bad morphology and thickness uniformity if the CVD process is not operated in an optimal condition. In addition, carbon source from the graphite insulation and improper coated graphite susceptor may also contribute to the doping in a CVD reactor, which is very difficult to be controlled in a reproducible way. Therefore, in paper 2, intentional carbon doping of (0001) GaN using six hydrocarbon precursors, i.e. methane (CH4), ethylene (C2H4), acetylene (C2H2), propane (C3H8), iso-butane (i-C4H10) and trimethylamine (N(CH3)3), have been explored. In paper 3, propane is chosen for carbon doping when growing the high electron mobility transistor (HEMT) structure on a quarter of 3-inch 4H-SiC wafer. The quality of epitaxial layer and fabricated devices is evaluated. In paper 4, the behaviour of carbon doping using carbon atoms from the gallium precursor, trimethylgallium (Ga(CH3)3), is explained by thermochemical and quantum chemical modelling and compared with the experimental results. GaN is commonly grown on foreign substrates, such as sapphire (Al2O3), Si and SiC, resulting in high stress and high threading dislocation densities. Hence, bulk GaN substrates are preferred for epitaxy. In paper 5, the morphological, structural and luminescence properties of GaN epitaxial layers grown on N-face free-standing GaN substrates are studied since the N-face GaN has advantageous characteristics compared to the Ga-face GaN. In paper 6, time-resolved photoluminescence (TRPL) technique is used to study the properties of AlGaN/GaN epitaxial layers grown on both Ga-face and N-face free-standing GaN substrates. A PL line located at ~3.41 eV is only emerged on the sample grown on the Ga-face substrate, which is suggested to associate with two-dimensional electron gas (2DEG) emission.